NETGEAR AV Series Hardware Installation Manual page 34

2
Figure 11. Package contents
To check the package contents:
1. Place the container on a clean flat surface, and cut all straps securing the container.
2. Unpack the hardware from the boxes by carefully removing the hardware and placing
it on a secure and clean surface.
3. Remove all packing material.
4. Verify that the package contains the following items:
Number Item
1 Switch of the model that you ordered.
Note: Rubber protection caps are installed in the SFP sockets. If you install an SFP transceiver
module, you must remove the cap from the SFP socket.
2 AC power cable (varies by region).
3 USB console cable.
4 Installation guide.
5 RJ-45 RS-232 console cable.
Installation
AV Line of Fully Managed Switches M4250 Series
1
3
5
7
6
8
34
4
9
Hardware Installation Guide