Getting Started - Canon ZV-223 User Manual

The device has a built-in battery. Please fully charge the device via the USB cable provided before using.
1. Insert the smaller end of the supplied USB cable into the device and other end into a chargeable USB
adapter.
2. The charging LED light, at the bottom of the device, will turn red to indicate charging.
3. Once fully charged, the charging LED will turn green.
- Operating time may vary depending on the battery status, operational status and environment
conditions.
An external MicroSD card (up to 256 GB) is needed for saving captured photos.
Only FAT16, FAT32 and exFAT format are supported.
PREPARING A MEMORY CARD
Use the following memory cards (sold separately)

MicroSD memory cards *1

MicroSDHC memory cards *1*2

MicroSDXC memory cards *1*2
*1 Cards conforming to SD standards. However, not all memory cards have been verified to work with the camera.
*2 UHS-I memory cards are also supported.
INSTALL AND REMOVE THE MicroSD CARD

Insert the MicroSD card into the slot at the bottom of the device. You will feel a slight click when the card
is fully inserted.

Push on the top of the card to release it. Gently pull to fully remove the card from the device.

If there is an error on ready / writing to the MicroSD card, the MicroSD Error LED Indication will be
displayed.

Connect the device to a computer by USB cable. Double-click the external drive image when it appears on
the computer to view and save the photos.

GETTING STARTED

CHARGING
Charging Status LED
Charging : Red
Full : Green
INSERTING SD CARD
3