Getting Started; Battery Removal And Installation - VTech Toot-Toot Cory Carson Cory’s Stay & Play Home Parents' Manual

GETTING STARTED

Battery Removal and Installation

1. Make sure the unit is turned OFF.
2. Locate the battery cover
underneath the second floor of
the house. Then, use a coin or a
screwdriver to loosen the screw
and remove the cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 3 new AAA (AM-4/LR03) batteries following the diagram
inside the battery box. (The use of new alkaline batteries is
recommended for maximum performance).
5. Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
• Use new alkaline batteries or fully charged NI-MH (Nickel Metal-
hydride) rechargeable batteries for best performance.
• Use only batteries of the same or equivalent type as
recommended.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
6
6
6
6