Summary of Contents for Pentair Pool Products Hydromatic SW33
Page 1
Pump Installation and Service Manual SW/SD/VS33 & 50 Submersible Sump/Effluent Pumps SD33 SW33 VS33 SW50 VS50 SD50 NOTE! To the installer: Please make sure you provide this manual to the owner of the pumping equipment or to the responsible party who maintains the system.
2. Risk of Electrical Shock: Approx. Turn-On Level General Connect only to a properly SW33A " Information grounded receptacle. SD33A " VS33A " Septic tank is to be vented Approx. Turn-Off Level Thank you for purchasing your accordance with local SW33A "...
7. Connect to power source using 3-prong grounded 115 volt receptacle. remove ground pin from electrical plug. Do not use an extension cord. 8. For proper automatic operation make sure the pump power cord is plugged into the back of the piggyback receptacle on the switch cord.
to a start position, replace the electrical components of the Pump complete piggyback switch pump. Starting with the power Servicing assembly and retest with cord, inspect for cuts or nicks new assembly. in the insulation. If the cord is damaged, it must be replaced! 5.
Page 5
4. If pump is using the series cord Check vent hole in pump case 1. Inlet in pump base may be plug, the two plugs may not be for plugging. clogged. Remove pump and plugged tight together. clean out openings. 2.
LIMITED WARRANTY HYDROMATIC warrants to the original consumer purchaser (“Purchaser” or “You”) of HYDROMATIC Sump Pumps, Effluent Pumps, Sewage Pumps (other than 2-1/2"), and Package Systems, that they will be free from defects in material and workmanship for the Warranty Period of 36 months from date of manufacture. Our warranty will not apply to any product that, in our sole judgement, has been subject to negligence, misapplication, improper installation, or improper maintenance.