Table of Contents
Advertisement
7. Connect to power source using
3-prong grounded 115 volt
AC
receptacle.
remove ground pin from
electrical plug. Do not use an
extension cord.
8. For
proper
operation make sure the pump
power cord is plugged into
the back of the piggyback
receptacle on the switch cord.
9. Use pump submerged for
pumping waterlike liquids
(temperature to 120°F).
WARNING:
Risk
Electrical Shock – This
pump
has
not
investigated
for
swimming pool areas.
10.CAUTION: Do not pump
flammable
liquids,
chemicals or salt water.
11.In applications where the
pump may sit idle for months
at a time, it is recommended
that the pump(s) be cycled
every
month
to
pumping system is working
properly when needed.
12.An audible alarm system such
as the Q Alert for high water
conditions should be installed
for
additional
against high water conditions.
Do
not
automatic
of
been
use
in
strong
ensure
protection
PERFORMANCE CURVE
Example one
SD50
Example one illustrates a typical system installation.
3
Advertisement
Table of Contents
