Setting The Speed Of The Camera Moving To A Preset Position - Sony RM-IP10 Operating Instructions Manual

We recommend that you check the stored settings
by recalling the preset.
To recall the stored settings
Press the GROUP/POSITION button in which you have
stored the settings.
For POSITION 9 to 16, hold down the SHIFT button
then press the GROUP/POSITION button.
Tip
To cancel preset recall of the camera, hold down the
RESET button, then press the PRESET button.
To cancel the preset memory
While holding down the RESET button (for POSITION
1 to 8) or the SHIFT and RESET buttons (for
POSITION 9 to 16), press the GROUP/POSITION
button from which you want to cancel the settings.
While holding down (for POSITION 1 to 8)
POSITION
Press a GROUP/POSITION button.
RESET
PRESET
1 2 3
SHIFT
9 10 11
While holding down (for POSITION 9 to 16)
The pressed button flashes during canceling of the
settings. Flashing stops when the settings have been
canceled.
Notes
• When the power is turned on, the camera starts with
the settings stored in POSITION 1.
• If you want to retain the previous pan and tilt positions
when the power is turned off and turned on again, store
those positions in POSITION 1.
• When you are storing or canceling the settings in one
POSITION, you cannot call up, store or cancel the
settings in another POSITION.
4 5 6 7 8
12 13 14 15 16
Setting the speed of the camera
moving to a preset position*
* The moving speed is stored in the internal memory of
the camera.
You can select the panning/tilting speed when the
camera moves to a preset position.
1
Press the CAMERA button to select the camera
whose speed you want to set.
To change camera group number (for IP
connection)
Press any GROUP/POSITION button while
holding down the SELECT button. (For selecting 9
to 16, select the camera group number while
holding down the SHIFT button.)
2
Press the GROUP/POSITION button for which you
want to set the speed for more than one second.
All the CAMERA buttons, 1 to 7, flash.
3
Press one of the CAMERA buttons to select the
speed.
CAMERA VISCA
1
button value*
1 04h (4)
2 0Ah (10)
3 0Dh (13)
4 10h (16)
5 13h (19)
6 16h (22)
7 18h (24)
2
19h (25)*
(default)
*1 For details on the setting of models which are not
mentioned above, refer to the VISCA value of each
model's command list.
*2 When BRC-X400/X401 or SRG-X400/201M2/X1
is connected.
Note
For SRG-360SHE, SRG-300SE, SRG-300H,
SRG-120DH, SRG-120DU and SRG-120DS, you
cannot set the speed when the camera moves to the
position. The camera always moves in maximum
speed.
Now the camera will move to the position preset to
the pressed GROUP/POSITION button with the
selected speed.
Storing the Camera Settings in Memory – Presetting Feature
Panning/tilting speed
(Unit: degree/sec.)
BRC-Z700, BRC-Z330
BRC-H900
1 1.3
2.2 3.4
4.8 5.4
11 11.6
23.3 23.9
43 43.4
60 (default) 60 (default)
19
GB