Chevrolet Trailblazer 2020 Owner's Manual page 209

Chevrolet Trailblazer Owner Manual (GMNA-Localizing-SE Asia/CenAmer/
Carib-13517615) - 2020 - CRC - 3/22/19
the clutch pedal. If four-wheel low
setting is selected when the vehicle
is in gear and/or moving faster than
5 km/h, the four-wheel low indicator
light will flash for 30 seconds but will
not complete the shift and the light
will go back to the original setting.
Shifting from Four-Wheel Low
to Two-Wheel High or
Four-Wheel High (4
To shift from four-wheel low 4 to
two-wheel high 2 or four-wheel
high 4 , the vehicle must be
stopped or moving less than 5 km/h
with the transmission in N (Neutral).
The preferred method for shifting
out of four-wheel low 4 is to have
your vehicle moving 1.6 to 3.2 km/h.
Rotate the shift control switch to the
two-wheel high 2 or four-wheel
high 4 position. You must wait for
the two-wheel high or four-wheel
high indicator light to stop flashing
and stay on before shifting the
transmission into gear or releasing
the clutch pedal. If two-wheel high
or four-wheel high setting is
selected when the vehicle is in gear
and/or moving faster than 5 km/h,
the two-wheel high or four-wheel
high indicator light will flash for
30 seconds but will not complete the
shift and the light will go back to the
original setting.
Shifting to Neutral (2
to Neutral)
to 2 or 4 )
Use N (Neutral) when you plan to
tow the vehicle. See Towing the
Vehicle 0 284 for towing
instructions. The vehicle must be
stopped. To shift the transfer case
into N (Neutral) with the key on
position ON, do the following:
1. Set the parking brake.
2. Press the brake pedal and shift
the transmission in N (Neutral).
3. Shift the transfer case to
two-wheel high 2 .
4. Rotate the shift control switch
clockwise past four-wheel low
4 to N (Neutral). Hold the
switch in the N (Neutral) setting
for at least 20 seconds or wait
Driving and Operating
until the red Neutral indicator
light stops flashing and stays
on. The N (Neutral) red
indicator light will come on
when the transfer case shift to
N (Neutral) is complete.
Note
Upon releasing the shift control
, 4 or 4
switch from N (Neutral) setting, the
switch will rotate to the four-wheel
low (4 ) setting. The transfer case
will remain in N with red N (Neutral)
indicator light illuminated until a new
setting is selected.
5. Press and hold the brake pedal
and shift the transmission to
R (Reverse) for 1 second, then
shift the transmission to D
(Drive) for 1 second to insure
the transfer case is in
N (Neutral). If the transfer case
is not in N (Neutral), repeat this
procedure starting at Step 3.
6. Place the transmission selector
lever in P (Park).
7. Turn the ignition to LOCK/OFF.
209