Table of Contents
Advertisement
220
SAFETY
Enhanced Accident Response System
Reset Procedure
After the event occurs, when the system is
active, a message regarding fuel cutoff is
displayed. Turn the ignition switch from ignition
AVV/START or MAR/ACC/ON/RUN to ignition
STOP/OFF/LOCK. Carefully check the vehicle
Customer Action
NOTE:
Each step MUST BE held for at least two seconds
1. Turn ignition STOP/OFF/LOCK. (Turn Signal Switch Must be placed in
Neutral State).
2. Turn ignition MAR/ACC/ON/RUN.
3. Turn right turn signal switch ON.
4. Place turn signal in neutral state.
5. Turn left turn signal switch ON.
6. Place turn signal in neutral state.
for fuel leaks in the engine compartment and on
the ground near the engine compartment and
fuel tank before resetting the system and
starting the engine.
Depending on the nature of the event the left
and right turn signal lights, located in the
instrument panel, may both be blinking and will
Right turn light BLINKS.
Left turn light is OFF.
Right turn light is ON SOLID.
Left turn light BLINKS.
Right turn light is OFF.
Left turn light BLINKS.
Right turn light BLINKS.
Left turn light is ON SOLID.
Right turn light BLINKS.
Left turn light is OFF.
continue to blink. In order to move your vehicle
to the side of the road, you must follow the
system reset procedure.
Customer Will See
Advertisement
Table of Contents
