Fiat 500X 2021 Owner's Manual page 107

system will not be controlling the distance
between your vehicle and the vehicle ahead.
The vehicle speed will only be determined by
the position of the accelerator pedal.
To Cancel
The following conditions cancel the system:
The brake pedal is applied.

The CANC button is pushed.

An Anti-Lock Brake System (ABS) event

occurs.
The gear selector is removed from the DRIVE

position.
The braking temperature exceeds normal

range (overheated).
The Electronic Stability Control/Traction

Control System (ESC/TCS) activates.
The vehicle parking brake is applied.

The driver switches ESC to Full Off mode.

To Turn Off
The system will turn off and erase the set speed
in memory if:
The Adaptive Cruise Control (ACC) on/off

button is pushed.
The Fixed Speed Cruise Control on/off button

is pushed.
The ignition is placed in the OFF position.

To Resume Speed
If there is a set speed in the memory, push the
RES button and then remove your foot from the
accelerator pedal. The instrument cluster
display will show the last set speed.
ACC or Fixed Speed Cruise Control can only be
resumed at speeds above 20 mph (32 km/h).
NOTE:
ACC cannot be resumed if there is a stationary
vehicle in front of your vehicle in close proximity.
STARTING AND OPERATING
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming
a set speed that is too high or too low for
prevailing traffic and road conditions could
cause the vehicle to accelerate or decelerate
too sharply for safe operation. Failure to
follow these warnings can result in a collision
and death or serious personal injury.
To Vary The Speed Setting
To Increase Or Decrease The Set Speed
After setting a speed, you can increase the set
speed by pushing the SET (+) button, or
decrease speed by pushing the SET (-) button.
U.S. Speed (mph)
Pushing the SET (+), or SET (-) button once

will result in a 1 mph speed adjustment. Each
subsequent tap of the button results in an
adjustment of 1 mph.
If the button is continually pushed, the set

speed will continue to adjust in 5 mph incre-
ments until the button is released. The new
set speed is reflected in the instrument
cluster display.
105
4