Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZKL 850 LX
Summary of Contents for Zanussi ZKL 850 LX
- Page 1 CERAMIC BUILT-IN HOB OPERATING INSTRUCTIONS...
-
Page 2: Safety Instructions
Please read these operating instructions carefully. Please make sure you read the safety instructions on the first pages of these operating instructions! Keep the operating instructions for future reference. Pass them on to any future owners. With the warning triangle and/or by means of key words (Warning!, Caution!, Important!), information is emphasized which is important for your safety or the correct functioning of the... -
Page 3: Table Of Contents
Safety Instructions ............. . . Electrical Safety . - Page 4 The safety aspects of this appliance comply with the accepted technical standards and the applicable safety regula- tions. Nevertheless, we consider it our obligation to make you aware of the following safety information: The new appliance may only be installed and con- nected up by qualified personnel, according to the manufacturers instructions and to the relevant country standards.
-
Page 5: Disposal
All packaging material can be recycled, shee- ting and hard foam parts are appropriately marked. Please dispose of the packaging ma- terial and any old appliance properly. Please observe national and regional regula- tions on appliances and packaging material, and the markings on the materials (material separation, waste collections, recycling de- pots). -
Page 6: Control Knobs
Rapid Cooking zone (double–ring) Rapid Cooking zone Rapid Cooking zone (double–ring) Rapid Cooking zone Residual heating indicators Control knobs Wipe the ceramic glass cooking surface with a damp cloth to remove any traces left from manufacturing. Important: Do not use any caustic or abrasive cleaners! The surface could be damaged. -
Page 7: Residual Heat Indicator
When the cooking zones are switched on, they may hum briefly. This is a characteristic of all ceramic glass cooking zones and does not im- pair either the function or the life of the applian- The control knob is used to set the required heat output continuously from 1–10. -
Page 8: Pans
The better the pan, the better the results. You can recognise good pans by their bases. The base should be thick and as flat as possible. Pay attention to the base diameter when purchas- ing pots or pans. Manufacturers often indicate the diameter of the upper edge of pots and pans. - Page 9 Important: Cleaners must not come into con- tact with the ceramic glass when hot! All clea- ners must be removed with plenty of clean wa- ter after cleaning as they may have a caustic effect when the rings are next heated! Do not use any aggressive cleaners, such as e.g.
-
Page 10: The Hob Frame
1. Remove burnt on sugar, melted plastic, aluminium foil or other melted materials immediately, while the hob is still hot, using a glass scraper. Important: When using the glass scraper on the hot cooking zone, there is a risk of burns! 2. - Page 11 Please check whether you can rectify small faults on the appliance yourself with the help of the following information. Should this information be of no assistance in a specific case, please contact your local Service Force Centre. Warning! Repairs to the appliance should only be carried out by approved service engineers. Improper re- pairs can cause injury or significant malfunction.
- Page 12 Low Voltage Directive 73/23/EEC and the amendment to LVD 90/683/EEC EMC Directive 89/336/EEC and the amendment to EMC 92/31/EEC CE Marking Directive 93/68/EEC 766 mm 506 mm 49 mm ZANUSSI 7.0 kW 230V, 230V 2, 400V 2-3N 750 mm 490 mm 750/2200 W...
- Page 13 The mains connection must be with a cable with a plug or there must be a disconnecting device with at least 3 mm contact opening in the existing do- mestic electrical installation, which disconnects the dishwasher completely from the mains supply in accordance with NIN 2000.
- Page 14 Make a note of the serial number on the ap- pliance rating plate prior to installation. This number will be required in the case of requests for service and is no longer accessible after in- stallation, as it is on the original rating plate on the underside of the appliance.
- Page 15 A type H05VV–F or higher quality lead must be used for the mains connection. The mains connection terminal is on the bottom of the appliance behind a cover. The cooking appliance should be connected as shown on the connection diagram, depending on the mains supply voltage.
-
Page 16: Something Not Working
For general enquiries concerning your Zanussi ap- pliance or for further information on Zanussi products, please contact our Customer Care Department by let- ter or telephone as follows:... - Page 18 374 3670 00 05.01 mh...