Control Panel Display - Salton GK1967 Instruction Booklet

CONTROL PANEL DISPLAY

Turning On the Control Panel:
Ensure that there is water in the Kettle between the MIN and MAX
markings. Press the finger indent on the Control Panel at the top of the
Handle and the display will light up. The display will show the current
water temperature.
Choosing Celsius or Fahrenheit
The default temperatures are in Celsius. To switch to Fahrenheit, press
and hold the Temperature icon
between °C and °F temperatures.
To Use the Boil Setting
1. Fill the Kettle with water (see instructions on page 4)
2. Turn on the Control Panel Display (see instructions above)
3. Tap the Power Icon
default temperature of 100°C. The lights will come on inside the
Kettle to indicate that it is in the heating cycle. The temperature will
flash 3 times then will switch to the current water temperature. The
Temperature Display will increase until it reaches 100°C or 212°F.
4. When the water has boiled the Kettle will shut off.
IMPORTANT: This Kettle has a Keep Warm feature than can be used
with the Variable Temperature settings. The maximum temperature
for this setting is 90°C/194°F. If this feature has accidently been
set (icon shows on the left side of the temperature display) then
you will not be able to set the Kettle to 100°C/212°F. Simply lift the
Kettle off the Power Base and start at #3 above.
To Use the Variable Temperature Settings
1. Fill the Kettle (see instructions on page 4)
2. Turn on the Control Panel (see instructions above)
3. Tap the Temperature Icon
100°C default temperature. The display will show the temperatures
starting from 40°C to 100°C in 10°C increments with each tap of the
Temperature Icon
NOTE:
a) the temperatures only go up. To set a temperature less than
100°C you need to tap the Temperature Icon
temperatures will start over from 40°C.
b) Do not hold the Temperature Icon
this will switch the Kettle between °C and °F temperatures. Quick taps
of the Temperature Icon
for 3 seconds and the Kettle will switch
once and the Kettle automatically sets to the
to change the temperature from the
.
will change the temperature.
past 100°C and the
to change the temperature as
5