Battery And Power Information; Recharging The Baeeries - Uniden HomePatrol-2 Owner's Manual

BATTERY AND POWER INFORMATION
HomePatrol-2 comes with an AC adapter to connect the unit to an AC power source and a DC adapter for
use in your automobile. In addiSon, HomePatrol-2 also requires four (4) AA Alkaline or NiMH
rechargeable baeeries (one set of four NiMH rechargeable baeeries is included with the unit).
NOTE: These rechargeable baNeries do not require a recharging sta%on; you can leave them in the
unit and select to recharge them when HomePatrol-2 is connected to AC power.
Installing the Batteries
From the back of the HomePatrol-2 unit:
6. Slide the baeery cover lock to the right to unlock the baeery cover.
7. Press and push down on the center to disengage the baeery cover.
8. Insert the baeeries according to the direcSonal label inside.
9. Replace and relock the baeery cover.
Recharging the Batteries
The rechargeable baeeries included with HomePatrol-2 are 2300 mAh. You can set how long it will take
to recharge a baeery from a drained state to a fully charged state through the Set Charge Time menu on
the Advanced Menu. The maximum recharge Sme HomePatrol accepts is 14 hours. Then, when you
connect HomePatrol-2 to a power source and allow baeery charging, HomePatrol-2 uses that data to
charge the baeeries. HomePatrol will charge the baeeries whether or not the unit is turned on, in
standby mode, or powered off.
When baeery power drops below a certain level, a Baeery Low pop-up displays the following message:
"Baeeries are low. Replay and Recording disabled. Connect external power to prevent data loss."
27