Filling With Salt - Zanussi ZT 6810 Instruction Booklet

Filling with salt

If your water is "level 0" it is already soft and therefore
there is no need to use salt.
Salt must be used from "level 1" upward.
Only use salt specifically designed for
use in dishwashers.
All other types of salt not specifically
designed for use in dishwasher,
especially table salt, will damage the
water softener.
Only fill with salt just before starting one of the
complete washing programmes (not the Rinse and Hold
programme). This will prevent any grains of salt or salty
water, which may have been spilled, remaining on the
bottom of the machine for any period of time, which
may cause corrosion.
To fill:
1. To fill with salt, unscrew the cap of the salt
container.
2. Pour about 1 litre of water inside the container,
or until it is full (this is necessary only before
filling with salt for the first time).
3. Then using the funnel provided, pour in the salt
until the container is full (approx. 2 kg).
Do not worry if water over flows from the unit
when filling with salt, this is quite normal.
4. Replace the cap making sure that there is no
trace of salt on the screw thread or on the
gasket.
5. Screw on the cap tightly.
The salt container will require topping up periodically.
You are reminded of this by the "Salt refill indicator
light" on the control panel which comes on when the salt
has finished (if level 0 has been selected, the indicator
light will always be on).
The "Salt refill indicator light" on the
control panel can remain illuminated
for 2-6 hours after the salt has been
replenished, assuming the dishwasher
remains switched on. If you are using
salts that take longer to dissolve then
this can take longer. The function of
the machine is not affected.
SR07
8 PFS08UK