Rinse Aid Refill Indicator; Digital Display - Zanussi ZT 6810 Instruction Booklet

2. Rinse aid refill indicator

light
This light illuminates when the rinse aid has run out,
and requires refilling.
3. Salt refill indicator light
This light illuminates when the salt has run out, to
remind you to refill the salt container.
4. "SID" indicator light
This light illuminates when you select a programme
with prewash.

5. Digital display

Displays the programme number, the programme time
or the time delay.
6. "Programme selector"
button
To select the required programme, press this button
until the number corresponding to the required
programme (e.g. P1 for Rinse and Hold) appears in the
digital display (see "Washing programmes" chart).
7. "Half load" pushbutton
By pressing this button, washing can be concentrated
to a single basket instead of both; the indicator light
corresponding to the basket selected comes on.
This is very useful and economical when only a few
dishes need washing.
Remember to load all the dishes into the basket
selected.
If both indicator lights are out, washing will be
carried out in both baskets (default setting).
8. "Economy drying"
pushbutton
By pressing this button you can opt to shorten (ECO
DRY) or completely omit the drying cycle (NO DRY).
The indicator light corresponding to the option
selected will illuminate.
With programme 1 (rinse and hold) and programme 10
(Plate warmer) this pushbutton is automatically
deactivated.
If both pilot lights are out, the full drying cycle will
be carried out (default setting).
9. "Delay start" pushbutton
Allows the start of the programme to be delayed by a
minimum of 1 hour, up to 12 hours.
How to set the "Delay start":
- When the button is pressed, in the display appears
"h 00".
- Press the button again to select the number of hours
which you wish to delay the programme start, up to
a maximum of 12 hours.
The delay start will not affect the programme settings.
10. "Cancel" pushbutton
If you press this button for at least 3 seconds after the
start of a programme (with open door) the selected
programme will be cancelled. A short intermittent
audible signal will be heard, and (---) will appear in
the digital display for 2 seconds, indicating that the
wash programme has been cancelled.
In the digital display will appear the programme
previously selected with relative options.
If this pushbutton is pressed for about 3 seconds
during the countdown of the delay start; the
countdown will be anulled but the other options are
still active and in the digital display will appear the
number of the programme selected.
At this point, the options can be changed and the
washing programme start or a new delay start can be
selected.
6 PCP21UK