What To Do If; Remedying Small Malfunctions - Zanussi Electrolux ZSF 6171 User Information

Bottom spray arm
1. To remove bottom spray arm, pull it upwards out of
its catch.
2. Clean spray arm jets.
3. Place bottom spray arm back in position against
connecting piece and press down firmly, until you
feel it snap into place.

What to do if...

Remedying small malfunc-
tions
If one of the following fault codes is displayed in the
multi-display during operation:
– Fault codeÅ 10 (Problems with water inlet),
– Fault codeÅ 20 (Problems with water drainage),
please have a look at the following table.
When the fault is remedied, press the button for the
cycle that has started. The cycle will continue.
With other fault codes ("Å " followed by a number):
– Abort the dishwashing cycle.
– Switch the appliance off and on again.
– Re-set the dishwashing cycle.
If the fault is displayed again, please contact your lo-
cal Service Force Centre and inform them of the fault
code.
Malfunction
The cycle indicator for the select-
ed dishwashing cycle is flashing:
the control indicator Water is lit,
fault code Å 10 is displayed in the
multi-display
(Problems with water inlet).
28
Possible cause
Water tap is blocked with limescale
or faulty.
The tap is turned off.
The filter (where present) in the
threaded hose fitting on the tap is
blocked.
Filters in the base of the washing
compartment are blocked.
Water inflow hose
has not been correctly positioned.
Remedy
Check the water tap and have it re-
paired if necessary.
Turn the tap on.
Clean the filter in the threaded hose
fitting.
Cancel the dishwashing cycle (see
chapter: Starting a dishwashing cy-
cle),
clean filters (see chapter: Cleaning
the filters),
then start the dishwashing cycle
again.
Check the position of the hose.