Zanussi Electrolux ZSF 6171 User Information page 10

Setting electronically:
1. Press the ON/OFF button.
3
If indicators for the programme buttons are lit,
a dishwashing cycle is activated. The dish-
washing cycle must be deselected:
Press function buttons 1 and 2 simultaneously
for approx. 2 seconds.
All additional wash programme button indica-
tors will go out.
2. Press function buttons 1 and 2 simultaneously and
keep them pressed.
The LED indicators for function buttons 1 to 3 will
flash.
3. Press function button 1.
The LED indicator for function button 1 will flash.
The multi-display will indicate the hardness setting.
4. Pressing function button 1 increases the hard-
ness setting by 1.
(Exception: hardness setting 1 follows hardness
setting 10).
5. When the hardness setting is correct, press the
ON/OFF button.
The hardness setting is now saved.
If the water softener is set electronically to "1", this
switches off the control indicator for dishwasher salt.
Water hardness
1)
in °d in mmol/l
51 - 70 9,0 - 12,5
43 - 50 7,6 - 8,9
37 - 42 6,5 - 7,5
29 - 36 5,1 - 6,4
23 - 28 4,0 - 5,0
19 - 22 3,3 - 3,9
15 - 18 2,6 - 3,2
11 - 14 1,9 - 2,5
4 - 10 0,7 - 1,8
below 4 below 0.7
1) (°d) German degree, measure of the hardness of water
2) [mmol/l] millimol per litre, international unit for water hardness
3) On this setting the length of the dishwashing cycle may be slightly longer.
*) factory setting
10
2)
Range
IV
III
II
I/II
I
Adjusting the hardness setting
Manual Electronic
1
0*
no salt necessary
Indication on the
multi-display
3)
10 10L .
9 9L
8 8L
7L
7
6 6L
5 5L
4* 4L
3L
3
2L
2
1
1L