Haier HWM180-M1990DD Owner's Manual page 10

Confirm the water faucet
The new hose-sets supplied with the appliance are to be used and that old hose-sets
should not be reused
water faucet,suitable
It is required that the front end shall be longer than 10mm.
The exit end face of the faucet shall be flat and smooth. If not
please file it to avoid leakage.
Connection between the water inlet hose jointer and the water faucet
1.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer
from the water inlet hose component. See to Figure 1.
2.Take off the nameplate. Make sure the threading is 4mm above the upper surface of the nut. See to
Figure 6. If the threading is less than 4mm above the upper surface of the nut. please loosen the
screws.
Lock level
3.Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the
faucet. See to Figure 2.(If the faucet is too large and the jointer can not be set on the water faucet,
please loosen the four screws and take out the bushing in the jointer. The front end of the faucet must
be smooth, otherwise it may leak water. See to Figure 3.)
4.Fasten the four screws evenly. See to Figure 4.
5.Twist the fastening nut, See to Figure 5. After installation, the threading is less than 2mm above the
upper surface of the nut. See to Figure 6.
The exit end face of the faucet
Water inlet hose jointer
Slider
Screw knife
Figure 1
Figure 4
water faucet, not suitable
Screw
Nameplate
Figure 2
Screw nut
Figure 5
Bushing
Figure 3
About 4mm before twisting
About less than 2mm after twisting
Figure 6