Advertisement
Installation (Cont.)
Connecting the water supply hose
• To prevent leakage or water damage, make sure to follow the instructions in this
section when connecting the washing machine to your water supply.
• Do not kink, crush, modify or sever the water inlet hose.
• Connect the supplied cold water supply hose to an ordinary laundry tap with a 3/4"
thread (Fig. 7). Installation should comply with all requirements and regulations of
your local water and building authorities.
• When there is a inlet valve at the back of the machine, it must be connected to a
cold water supply. (If there are two inlet valves, one must be connected to a cold
water supply and the other to a hot water supply.) Follow the pictorial instructions
below (Fig. 8) to complete the connection.
Fig. 8
• Turn on the tap and check for leaks. In case of leakage, repeat the connection
steps above, or tighten the nut more firmly. If your water pressure is strong, close
the water tap completely, then open it slightly.
• When tightening the coupling nut, take care not to damage the water inlet valve
joint. Apply force evenly and do not twist the water inlet valve.
• Use only the new (supplied) hose with your new appliance. Do not use a hose
from an existing machine, or one that has been used previously.
14
(AU) 1300 886 649 (NZ) 0800 836 761 |
WARNING!
Fig. 7
Inlet valve for cold water
inlet valve for cold water
inlet hose for cold water with a white nut
Inlet hose for cold water (with a white nut)
CAUTION!
After Sales Support
info@tempo.org
Hide quick links:
Advertisement
