Zanussi ZCE 650 Instruction Booklet page 23

How to use the pyrolytic clean-
ing function
Before activating the pyrolytic cleaning function,
remove any excessive spillage and make sure
that the oven is empty. Do not leave anything
inside it (e.g. pans, grids, baking tray, drippin pan)
as this could severely damage them.
Ensure that the oven door is closed before
activating the pyrolytic cleaning function.
When the pyrolytic cleaning function is on, it is
advisable not to use the hob as this could cause
overheating and damage the appliance.
During the pyrolytic cleaning cycle the oven door
becomes hot. Children should be KEPT AWAY
until it has cooled.
Choose this function to clean the oven by pyrolysis.
The following pyro levels are available:
Pyrolytic 1 (PYr I) time : 2 h = 30 min heat-up +1 h at
480°C + 30 min cooling down.
Pyrolytic 2 (PYr 2) time : 2 h 30 min. = 30 min heat-up
+1 h 30 min at 480°C + 30 min cooling down.
The pyrolytic cleaning cycle duration/time cannot
be changed.
1. Turn the oven knob to position
indicator and the PYr I indication will flash in the dis-
play (Fig. 22).
2. Press "Pyrolytic" button to activate the pyrolytic
cleaning function. The temperature indicators will
start lighting alternatively. This means that the oven
is rapidly heating up.
The "PYr I" indication will stop to flash, the oven light
will go out and the pyrolytic cleaning cycle will start
(Fig. 24).
If the oven cavity is very dirty, we advise you to select the
pyrolytic 2 function (PYr 2) on the programmer display.
1. Press "Pyrolytic" button to select the pyrolytic 2 (PYr
2) function.
Press button "Time" to display the remaining time.
After some time, the temperature level indicators will
light permanently in the display. This means that the
oven door has been locked.
At the end of the pyrolitic cleaning process, "0.00" will
flash in the display.
Once the oven has cooled down (check the temperature
level indicators coming off one by one), the oven door will
unlock.
To reset the oven, turn the oven function control knob to
the "OFF" position (0).
If you press a button other than the knob, the alarm will
switch off and the display will show "--- °C". This means
that the oven cannot be operated.
To reset the oven, turn the oven function control knob to
the "OFF" position (0).
To stop the pyrolytic cleaning cycle at any time, turn the
oven function control knob to the "OFF" position (0).
NOTE: The time indication is comprehensive of the
cooling down time.
. The "Cook Time"
23