Advertisement
MN103S Emulator Target conversion adapter Installation
1. Replace screws on the bottom
surface of the emulator housing by
screws with spacers and rubber
feet.
*2
5-1. Tighten the rear two
screws evenly.
*1
*2
8. Insert the target socket board
(EXB-128SD-PA) along YQ-Guide .
(straight from on.)
Note:
*1 When connecting parts, make sure to join the marks "1 pin" and "A1" respectively.
*2 Special attentions should be paid to needle-points of YQPACK and the conversion board
not to bend or break them.
2. The screws have been replaced.
Alternate
5-1 and 5-2
*2
5-2. Tighten the front two
screws evenly.
9. Connect the flexible cables with
the conversion board and the target socket board.
S/N. 081-31E-624A1-103S
*1
*2
3. Insert the longer side of
joining screws into the emulator
housing.
6. The conversion board has
been installed if there is
no space.
Software & Solutions Development Center
Corporate System LSI Development Division
Semiconductor Company
Matsushita Electric Industrial Co., Ltd.
Apr 14, 2008
4. Put the conversion board on the
joining screws.
(Make sure to join the mark "A1")
Ex) Target board
7. Screw NQPACK (Sold separately)
and YQPACK by YQ-Guide.
(Note the corner cut)
10. Installation has been completed.
3
Advertisement
