Fuel system
Assembly
Connect the fuel hoses to the carburettor
and screw it on to the distance piece.
Do not forget the top screw!
Assembly
1. Connect the fuel hoses to the carburet-
tor.
2 Hold the carburettor against the air
fi lter holder and push in the carburettor
screws.
3. Place the gasket against the carburet-
tor and over the screws.
4. Hold the carburettor against the dis-
tance piece and screw in position.
Do not forget the top screw!
5. Place the tank venting valve in its
bracket.
6. Connect the throttle cable.
Throttle
Remove the screws holding the throttle
handle against the shaft attachment and
the 4 screws holding the handle halves
together.
Lift off the right hand handle half and care-
fully note how the different parts are fi tted.
Lift off the catch (A) for unintentional full
throttle and replace if needed.
Lift up the throttle cable (B) from the chan-
nel and unhook it from the throttle (C) and
replace if needed.
To continue dismantling to access for
instance the short-circuit switch or to
replace the throttle (C), the screws (D)
are loosened after which the shaft can be
removed from the throttle handle half.
Assemble the throttle handle in the re-
verse order as set out for dismantling.
502 71 27-02
3
23