Kenwood KRC-459R Instruction Manual page 29

Removing the hard rubber frame
1
Engage the catch pins on the removal tool and remove the tw o
locks on the low er level.
Low er the frame and pull it forw ard as show n in the figure.
2
When the low er level is removed, remove the upper tw o loca-
tions.
N OTE
The frame can be removed from the top side in the same man-
ner.
Downloaded from: http://www.usersmanualguide.com/
Catch
Lock
Accessory 2
Removal tool
Removing the Unit
1
Refer to the section " Removing the hard rubber frame" and
then remove the hard rubber frame.
2 Remove the Hex-head screw w ith integral w asher (M 4 × 8) on
the back panel.
3
Insert the tw o removal tools deeply into the slots on each side,
as show n.
Accessory 3
4
Low er the removal tool
tow ard the bottom, and pull
out the unit halfw ay w hilst
pressing tow ards the
inside.
2CA U TION
Be careful to avoid injury from the catch pins on the removal tool.
5
Pull the unit all the w ay out
w ith your hands, being care-
ful not to drop it.
— 29 —
Catch facing up