Changing The Default Settings - Epson Stylus Color 980 Manual

Network I/F mode
Parallel I/F transfer rate
Software
Auto CR (IBM mode
only)
AGM (IBM mode only)
Auto line feed
0 slash
Character table
Note:
Most software controls the character table and auto line feed. If your
software controls these features, you may never need to set them with
the control panel.

Changing the default settings

To change the printer's default settings, use the control panel
buttons. Your selections are indicated by the control panel lights.
Follow the steps below.
1. Make sure that the printer is turned off and that A4 or Letter
size paper is loaded in the sheet feeder.
Off, On
Fast, Normal
ESC/P 2, IBM X24E
Off, On
Off, On
Off, On
0, 0 with slash
Standard model: Italic, PC437, PC850,
PC860, PC861, PC863, PC865, BRASCII,
Abicomp, Roman 8, ISO Latin 1, PC858, ISO
8859-15
All other models: Italic, PC437,
PC437 Greek, PC850, PC852, PC853,
PC855, PC857, PC866, PC869, MAZOWIA,
Code MJK, ISO 8859-7, ISO Latin 1T,
Bulgaria, PC774, Estonia, ISO 8859-2,
PC866 LAT, PC866 UKR, PCAPTEC, PC708,
PC720, PCAR864, PC860, PC861, PC863,
PC865, BRASCII, Abicomp, Roman 8, ISO
Latin 1, PC858, ISO 8859-15
Using the Printer Software for DOS
12-3