Changing Actuator Mounting Style; Parts Ordering; Parts Kits - Emerson FISHER CV500 Instruction Manual

CV500 Valve

Changing Actuator Mounting Style

Refer to figure 3 of this manual and the actuator
instruction manual when changing mounting styles
or positions. Right-hand mounting places the
actuator on the right side of the valve as viewed from
the upstream side of the valve; left-hand mounting
places the actuator on the left side of the valve.
Remember that the upstream side of the valve inlet
is the retainer end of the valve body for forward flow
and the other end of the valve body is the upstream
side for reverse flow.
Complete the Adjusting Actuator Travel procedure in
this manual whenever the actuator is removed.

Parts Ordering

A serial number is assigned to each valve body and
stamped on the nameplate. Always refer to this
serial number when corresponding with your
Emerson Process Management sales office
regarding spare parts or technical information. When
ordering replacement parts, also specify the
complete 11-character part number from the Parts
List.
Use only genuine Fisher replacement
parts. Components that are not
supplied by Emerson Process
Management should not, under any
circumstances, be used in any Fisher
valve, because they will void your
warranty, might adversely affect the
performance of the valve, and might
jeopardize worker and workplace
safety.
Neither Emerson, Emerson Process
Management, Fisher, nor any of their
affiliated entities assumes
responsibility for the selection, use
and maintenance of any product.
Responsibility for the selection, use,
and maintenance of any product
remains with the purchaser and
end-user.
20
Note
Note

Parts Kits

Repair Kits
Repair kits include recommended spares for
standard and sealed bearing constructions.
VALVE SIZE, INCHES
3
4
6
8
Parts Included in Kits
Key Number Description
9 Expansion pin
10 Taper pin
11 Retainer gasket
19 O-ring (sealed bearing only)
20 O-ring (sealed bearing only)
Retrofit Kits for ENVIRO-SEAL Packing
Retrofit kits include parts to convert existing Design
CV500 valves with single depth packing box to the
ENVIRO-SEAL packing box construction. Retrofit
kits include single PTFE or graphite packing box
construction (see the following table).
SHAFT DIAMETER
VALVE
SIZE
mm Inches
3 25.4 1
4 31.8 1-1/4
6 & 8 38.1 1-1/2
10 44.5 1-3/4
12 53.8 2-1/8
Parts Included in Kits
Description
Key
100
Packing Stud Packing Stud
101
Packing Nut Packing Nut
Packing Packing
102
Flange Flange
Spring Pack Spring Pack
103
Assembly Assembly
105 Packing Set Packing Set
Anti-Extrusion Anti-Extrusion
106
Washer Washer
Packing Box Packing Box
107
Ring Ring
Instruction Manual
Form 5302
July 2006
REPAIR KIT NUMBER
RV500X00042
RV500X00052
RV500X00062
RV500X00072
Quantity in Kit
1
1
1
2
2
PART NUMBER
Single PTFE Graphite
RRTYXRT0052 RRTYXRT0352
RRTYXRT0062 RRTYXRT0362
RRTYXRT0072 RRTYXRT0372
RRTYXRT0682 RRTYXRT0822
RRTYXRT0722 RRTYXRT0862
Quantity in Kit
Single PTFE Graphite
2 2
2 2
1 1
1 1
1 1
2 - - -
1 1