Snapper XD Series Owner's Manual page 14

ASSEMBLy
BaTTERY
i M P O R T a n T
The battery pack is not charged when it is purchased. Before using the chain saw for the first time,
place the battery pack in the battery charger and charge it fully. Be sure to read all safety
precautions, and follow the instructions in the section entitled Charging Procedure. With regular
use, the battery will require shorter charging times. When storing the chain saw for a prolonged
period of time, remove the battery. When the chain saw is going to be used again, charge the
battery pack for at least a full charging period. This product has no memory effect.
TO inSTaLL ThE BaTTERY:
1. Align the battery pack (3) with the battery compartment on the chain saw.
2. Grasp the chain saw (2) firmly.
3. Push the battery pack into the battery compartment until the latch locks into place.
4. you should hear a "click" once the battery is installed.
i M P O R T a n T
This Lithium-ion battery pack is equipped with an internal circuit breaker which will automatically
shut off the power to the tool if overloaded.
If this occurs, release the trigger to reset the internal circuit breaker.
i M P O R T a n T
• Make sure the chain brake is not engaged;
• Pull back on chain brake guard;
• Press the O/I button to turn the unit on;
14