Snapper XD Series Owner's Manual page 13

ASSEMBLy
w a R n i n G
Do not insert the battery until assembly is complete. failure to comply could result in accidental
starting and possible serious personal injury.
aDDinG BaR anD Chain LUBRiCanT
Use a bar and chain lubricant with this product. It is designed for chains and chain oilers, and is
formulated to perform over a wide temperature range with no dilution required.
• Remove oil cap.
• Carefully pour the bar and chain oil into the tank.
• Wipe off excess oil and replace cap.
• Check and fill the oil tank when quick view oil indicator is below the MIN. line.
• Repeat as needed.
nOTE: Chain saw comes from the factory with no bar and chain oil added. The level should also
be checked after every 20 minutes of use and refilled as needed.
nOTE:
• Do not use dirty, used or otherwise contaminated oils. Damage may occur to the bar or
chain.
• It is normal for oil to seep from the saw when not in use. To prevent seepage, empty the
oil tank after each use then run for one minute. When storing the unit for a long period of
time (three months or longer) be sure the chain is lightly lubricated; this will prevent rust
on the chain and bar sprocket.
Oil Reservoir
Cap
Quick view oil indiacator
13