Introduction; The Trx-Ii Calibrator; Pressure Measurements And Calibrations; Automatic Calibration - GE Druck TRX-II User Manual

INTRODUCTION

The TRX-II Calibrator

The Multi-Calibrator model TRX-II has been designed for testing and
calibration of process instrumentation and portable test equipment.
The unit provides data to comply with the ISO 9000 requirements for
calibration. The TRX-II can be used to measure and source
analogue and digital signals often used in an industrial environment.
It can also be used to simulate a wide variety of temperature sensors.
Measurement and source/simulation functions can be operated and
read simultaneously.
Model TRX-II IS marked with label "Ex" has been built in accordance
with European Norm II 2 (1) G EEx ia IIC T5 and may be used in IEC
defined zones 0,1 and 2. for special precautions for use deviations to
the standard unit see the chapter "SUPPLEMENT FOR
INTRINSICALLY SAFE CALIBRATOR TRX-II iS".

Pressure Measurements and Calibrations

A range of pressure sensors is optionally available for pressure
measurements and calibration.

Automatic Calibration

To automate calibration routines and to store calibration data the unit
has been provided with a memory card slot. For the same purpose
the unit has a RS232 cable connector to interface directly with a
Personal Computer. To perform automatic calibration, in the field or
in the workshop, the TRX-II is supported by a Druck Calibration
Management software. The software package and Memory Cards
are optionally available from your local Druck Sales Office or
Distributor.

Standard Accessories

The standard TRX-II Calibrator is packed together with the following
parts:
Operating Manual
Test leads (5x)
Carrying Case
Alkaline Batteries LR14 or C (4x)
Spare fuses 400 mA (3x)
Calibration certificate

Optional Accessories

Line Adaptor/Charger 230 V
Line Adaptor/Charger 115 V
Line Charger 230 V
Line Charger 115 V
Pressure Sensors
Calibration Management Software
K319 Issue 2
#13603/230
#13603/115
#13603/230 iS
#13603/115 iS
EN-1