Installing The Throttle Body Joints; Installing The Air Filter Case Joints - Yamaha Tenere 700 2020 Service Manual

EWA16640
WARNING
Cover fuel hose connections with a cloth
when disconnecting them. Residual pres-
sure in the fuel lines could cause fuel to
spurt out when removing the hoses.
ECA20010
NOTICE
Be sure to disconnect the fuel hose by hand.
Do not forcefully disconnect the hose with
tools.
c. Connect the pressure gauge "4" and
adapter "5" to the fuel hose "3".
Pressure gauge
90890-03153
Pressure gauge
YU-03153
Fuel pressure adapter
90890-03176
Fuel pressure adapter
YM-03176
4 5
d. Start the engine.
e. Measure the fuel pressure.
Fuel line pressure (at idle)
300–390 kPa (3.0–3.9 kgf/cm²,
43.5–56.6 psi)
Faulty → Replace the fuel pump.
3. Install:
• Fuel tank
Refer to "FUEL TANK" on page 7-1.
• Fuel tank side covers
Refer to "GENERAL CHASSIS (3)" on page
4-5.
• Rider seat
Refer to "GENERAL CHASSIS (1)" on page
4-1.
EAS30937

INSTALLING THE THROTTLE BODY JOINTS

1. Install:
3
• Throttle body joints "1"
TIP
Be sure to install the throttle body joints "1" as
shown in the illustration.
a
A
45˚
a. #1 cylinder
b. #2 cylinder
A. Left
B. Right
3
EAS33279

INSTALLING THE AIR FILTER CASE JOINTS

1. Install:
• Air filter case joint clamps "1"
TIP
• Align the projection on the air filter case joint
with the slot in the air filter case joint clamp.
• Face the screw head of the air filter case joint
clamp outward.
7-13
THROTTLE BODIES
Fuel tank mounting bracket bolt
10 N·m (1.0 kgf·m, 7.4 lb·ft)
Throttle body joint clamp screw
3.0 N·m (0.30 kgf·m, 2.2 lb·ft)
1
70˚
Air filter case joint clamp screw
3.0 N·m (0.30 kgf·m, 2.2 lb·ft)
b
B