Fein Turbo II X Instruction Manual page 17

OBJ_BUCH-0000000234-002.book Page 17 Tuesday, August 1, 2017 8:47 AM
Mounting and cleaning the flat-fold
filter (figure 10).
Changing the filter, see Section "Trouble-
shooting."
Wear personal protective equipment (respi-
ratory mask, protective gloves) when chang-
ing the filter.
The filter may only be changed in rooms suit-
able for this, where other persons are not at
hazard.
After removing the contaminated filter, clean
the clean-gas side and the sealing surfaces
using commercially available, non-scouring
cleaning agents and water.
Fig. 10
2.
1.
Never vacuum without the
CAUTION
flat-fold filter, as otherwise
the motor will become damaged and
increased output of fine dust may pose a haz-
ard to one's health.
Before switching from wet to dry vacu-
uming, allow the wet flat-fold filter to
dry or replace with a dry flat-fold filter. Oth-
erwise, the flat-fold filter will become unus-
able.
Keep the flat-fold filter dry and clean it regu-
larly.
The requirements of the EPA Directive (RRP)
are only fulfilled when the HEPA filter is used.
For this, the HEPA filter must be in good con-
dition and used properly.
en
17