Returning To The Factory Settings; Installing Batteries - Boss HYBRID DRIVE OD-200 Owner's Manual

Appendix

Returning to the Factory Settings

(Factory Reset)
Here's how to return the OD-200 to its factory-set state.
1.
While holding down the [ON/OFF] switch and
[MEMORY/BOOST] switch, turn on the power
(insert a plug into the INPUT jack).
The display indicates "FCt. "
2.
Press the [MEMORY/BOOST] switch.
The display indicates "Sur. "
If you decide to cancel, press the [MEMORY] button.
3.
Press the [MEMORY/BOOST] switch.
The factory reset is executed.
4.
When the display indicates "FIn," turn the
power off and on again.
14

Installing Batteries

Insert the batteries as shown below, being careful to
orient the batteries correctly.
* Batteries should always be installed or
replaced before connecting any other
devices. This way, you can prevent
malfunction and damage.
* If operating this unit on batteries, please
use alkaline batteries.
* Even if batteries are installed, the unit
will turn off if you connect or disconnect
the power cord from the AC outlet while
the unit is turned on, or if you connect or
disconnect the AC adaptor from the unit.
When this occurs, unsaved data may be
lost. You must turn off the power before
you connect or disconnect the power cord
or AC adaptor.
* When turning the unit over, be careful so
as to protect the buttons and knobs from damage. Also, handle the unit
carefully; do not drop it.
* If you handle batteries improperly, you risk explosion and fluid leakage.
Make sure that you carefully observe all of the items related to batteries
that are listed in "USING THE UNIT SAFELY" and "IMPORTANT NOTES"
(leaflet "USING THE UNIT SAFELY").
* "Lo" will appear on the display if the batteries are low. Replace them with
new ones.