Toro 30701 Installation Instructions Manual

North American Cab Light Kit
2015 and After Groundsmaster
Machine and Groundsmaster
Model No. 30701
Installation
1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key from the
ignition switch.
4. Remove the negative battery cable from the
battery.
2
Installing the Headlights
Parts needed for this procedure:
2 Flange-head bolt (3/8 x 1 inch)
2 Flange locknut (3/8 inch)
2 Washer (3/8 inch)
2 Mounting bracket
2 Headlight assembly
Procedure
1. Remove the hardware from the light
2. Discard the existing bracket and hardware
shown in Figure
3. Install the new bracket with the hardware from
the light (Figure 1).
4. Install the lights to the machine as shown in
Figure 1.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
(Figure
1.
Register at www.Toro.com.
® 360 4-Wheel Drive Multi Purpose
® 3280 Series Cab
Groundsmaster 360 machine shown
1. Headlight
2. Flat washer (3/8 inch)
3. Flange nut (3/8 inch)
4. Short harness
1).
Original Instructions (EN)
Form No. 3437-283 Rev A
Installation Instructions
Figure 1
5. Bolt (3/8 x 1 inch)
6. Use this hardware with the
light.
7. Mounting bracket
8. Discard this hardware
All Rights Reserved *3437-283* A
Printed in the USA
g310011