What To Do If Your Appliance Does Not Work - Moulinex INFINY PRESS REVOLUTION ZU500 Manual

Make sure to clean the inside of the screw (C) carefully; if necessary, use the brush (P).
Clean the residue exit (K) with a lightly moist and non-abrasive sponge.
The pusher (A), the feed tube (B), the bowl (G), the screw (C), the juice collector (H) with
the spout with drip-stop (I), the jugs (N), and the foam separator (O) can all go into the
dishwasher. If the filters (D/E) are clogged, prewash them with warm water and washing up
liquid and use the brush (P). If the filter residue exit is clogged, remove the residues using the
other end of the brush (P).
Do not clean the juice collector (H), the spout with drip-stop (I), the plastic parts (bowl (G),
food presser (A), feed tube (B)) with the abrasive side of the sponge.
Tips: To extract the screw (C) from the filter (D/E), turn both pieces together and then press
on the screw.

WHAT TO DO IF YOUR APPLIANCE DOES NOT WORK

PROBLEMS
The appliance does not turn
on
The appliance stops suddenly
while functioning: the red
light flashes
The appliance turns off: the
white light flashes
Poor Juice Extraction
Problems related to leaking
SOLUTIONS
- Make sure that all parts are correctly assembled.
- Make sure that your appliance is properly plugged in.
- Check that the feed tube (B) is correctly locked in
position.
- Press the Start/Stop button (M) to switch off the
appliance.
- Start your appliance again. If the safety mechanism
shuts the appliance off again, take it apart, clean it and
turn it on again.
- Make sure that the screw (C) is not blocked.
- This is a safety mechanism. We recommend that you let
the appliance cool down for a few minutes, clean it, and
then restart it by pressing the Start/Stop button (M).
- Clean the appliance: wash, rinse out and dry: the feed
tube (B), the pressing screw (C), the filter (D or E),
the residue strap (F), the bowl (G), the jugs, the spout
(H and I) and the dry residue colector (Q).
- Make sure that the strap (F) is correctly positioned on
the filter (to collect residues) and that it is in good
condition.
- Check that all parts are correctly assembled, especially
the spout with drip-stop (I).
6