Impedance Selector Switch; Connecting The Power Supply Cords - Yamaha HTR-5450RDS Owner's Manual

CONNECTIONS

IMPEDANCE SELECTOR Switch

WARNING
Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise the unit may be
damaged.
If this unit fails to turn on when STANDBY/ON (or POWER) is pressed, the IMPEDANCE SELECTOR switch may not
be fully slid either position. If so, slide the switch to either position fully when this unit is in the standby mode.
Select the right or left position according to the impedance of speakers in your system. Be sure to move this switch only
when this unit is in the standby mode.
IMPEDANCE
SELECTOR
IMPEDANCE SELECTOR
SET BEFORE POWER ON
MAIN A OR B: 8 MIN. /SPEAKER
A + B:16 MIN. /SPEAKER
CENTER : 8 MIN. /SPEAKER
REAR : 8 MIN. /SPEAKER
MAIN A OR B: 4 MIN. /SPEAKER
A + B: 8 MIN. /SPEAKER
CENTER : 6 MIN. /SPEAKER
REAR : 6 MIN. /SPEAKER

Connecting the Power Supply Cords

After completing all connections, connect the AC power cord to an AC power outlet. Disconnect the AC power cord if you
will not use this unit for a long period of time.
I AC OUTLETS (SWITCHED)
IMPEDANCE SELECTOR
SET BEFORE POWER ON
MAIN A OR B: 8 MIN. /SPEAKER
A + B:16 MIN. /SPEAKER
CENTER : 8 MIN. /SPEAKER
REAR : 8 MIN. /SPEAKER
MAIN A OR B: 4 MIN. /SPEAKER
A + B: 8 MIN. /SPEAKER
CENTER : 6 MIN. /SPEAKER
REAR : 6 MIN. /SPEAKER
18
(Europe model)
MAINS
AC OUTLETS
SWITCHED
100W MAX. TOTAL
(Europe model)
MAINS
AC OUTLETS
SWITCHED
100W MAX. TOTAL
To AC outlet
SWITCHED
Switch Speaker
position
If you use one set of main speakers, the impedance of
each speaker must be 4 Ω or higher.
Main
If you use two sets of main speakers, the impedance of
Left
each speaker must be 8 Ω or higher.
The impedance must be 6 Ω or higher.
Center
The impedance of each speaker must be 6 Ω or higher.
Rear
If you use one set of main speakers, the impedance of
each speaker must be 8 Ω or higher.
Main
If you use two sets of main speakers, the impedance of
Right
each speaker must be 16 Ω or higher.
The impedance must be 8 Ω or higher.
Center
The impedance of each speaker must be 8 Ω or higher.
Rear
Europe model .................................................... 2 OUTLETS
U.K. model .......................................................... 1 OUTLET
Use these outlets to connect the power cords only from your
audio/video components to this unit. The power to the AC
OUTLET(S) is controlled by this unit's STANDBY/ON (or
POWER). These outlets will supply power to any connected
component whenever this unit is turned on. The maximum
power (total power consumption of components) that can be
connected to the AC OUTLET(S) is 100 W.
Impedance level