Metra Electronics Chrysler 300 Installation Instructions Manual page 2

1. Unclip and remove the top half of the
shift knob. (Figure A)
2. Remove (1) T-30 Torx screw securing the
knob and then remove. (Figure B)
3. Unclip and remove the panel
surrounding the shift knob. (Figure C)
2
DASH DISASSEMBLY
(Figure A)
(Figure B)
(Figure C)
4. Unclip and remove the climate control/
radio control panel.
Note: The harness removed from
this panel will connect to the climate
extension cable. (Figure D)
5. Remove (2) Phillips screws securing the
pocket below the climate control panel,
and then unclip and remove the pocket.
(Figure E)
6. Remove the (4) Phillips screws securing
the radio chassis, and then unplug and
remove it from the dash cavity.
Note: The white round cable connected
to the radio chassis will connect into
the Axxess interface to drive the factory
display screen.
Continue to Kit Assembly
(Figure D)
(Figure E)
|
1.800.221.0932 MetraOnline.com