Mechanical Instructions - Philips TE3.1E CA Service Manual

4. Mechanical Instructions

Index of this chapter:
4.1 Exploded view
4.2 Rear Cover Removal
4.3 Service Position Main Panel
4.4 Side I/O Panel Removal
4.5 Rear Cover Mounting
4.1 Exploded View
4.2 Rear Cover Removal
1. Remove all fixation screws (9x) of the rear cover.
2. Pull the rear cover a little backwards.
3. Now pull the rear cover backwards to remove it.
4.3 Service Position Main Panel
1. Remove the main panel [1]. At the same time, pull the
panel away from the CRT [2].
2. Turn the panel 90 degrees clockwise [3].
3. Flip the panel 90 degrees [4], with the components towards
the CRT
4.4 Side I/O Panel Removal
Remove the side I/O panel after unscrewing the screws (2x) at
the bottom of the set.
4.5 Rear Cover Mounting
To reassemble the set, perform all described processes in
reverse order.
Be sure that, before the rear cover is mounted:
• The mains cord is mounted correctly in its guiding bracket.
• All wires/cables are returned in their original position
Mechanical Instructions
Figure 4-1 Exploded view
TE3.1E CA 4.
F_15850_028.eps
20050824
EN 7