Initializing The Current Settings - Yamaha YSP-1000 Owner's Manual

ADJUSTING SYSTEM PARAMETERS
4
Press / to switch between PROTECT: ON
and PROTECT: OFF.
PROTECT: ON
PROTECT: OFF
• Select PROTECT: ON to activate the protection
feature.
• Select PROTECT: OFF to deactivate the protection
feature.
5
Press STANDBY/ON on the front panel or on
the remote control to set this unit to the
standby mode.
STANDBY/ON
Front panel
The new setting will be activated when you turn on
the power of this unit next time.
82
ENTER
VOL
VOL
or
Remote control

Initializing the current settings

You can reset all of the parameters of this unit to the
factory presets. This procedure completely resets ALL the
parameters in SET MENU.
Note
After performing the following procedure you must reset the
ROOM TYPE, SP POSITION and ROOM SIZE parameters to
match your surround sound environment.
1
Repeat steps 1 to 3 in "Setting the maximum
volume level" on page 80.
2
Press / on the remote control so that
FACTORY PRESET is shown in the front
panel display.
FACTORY PRESET
3
Press ENTER.
ENTER
VOL
ENTER