Yamaha YSP-1000 Owner's Manual page 105

Digital sound projector

Hide thumbs Also See for YSP-1000:

Brochure (8 pages)

Quick reference manual (2 pages)

Service manual (92 pages)

Table Of Contents

100

101

102

103

104

105

106

Table of Contents

YSP-1000 QUICK REFERENCE GUIDE

This quick reference guide explains steps to connect a TV and a DVD player to this unit and achieve the surround sound effects in a quick, easy manner.

Before installing this unit

This unit creates surround sound by reflecting projected sound beams off the walls of your listening room.

The surround sound effects produced by this unit may not be sufficient when the unit is installed in the following locations.

• Rooms with surfaces inadequate for reflecting sound beams

• Rooms with acoustically absorbent surfaces

• Rooms with measurements outside the following range W (3 to 7 m) x H (2 to 3.5 m) x D (3 to 7 m)

• Rooms with less than 2 m from the listening position to the speaker positions

• Rooms where objects such as furniture are likely to obstruct the path of sound beams

• Rooms where the listening position is close to the walls

• Rooms where the listening position is not in front of this unit

Make sure you leave an adequate amount of ventilation space so that heat can escape. Make at least 5 cm of space above or below this unit.

Installing this unit

Install this unit where there are no obstacles such as furniture obstructing the path of sound beams. Otherwise, the desired surround sound effects may not be achieved.

You may install this unit in parallel with the wall or in the corner.

Parallel installation

Install this unit in the exact center of the wall when it

is measured from the left and right corners.

An object, such as furniture

Installation example

Install this unit so that the sound beams

can be reflected off the walls.

Wrong

Printed in Malaysia

WG29110

Side view

5 cm or more

Front

Corner installation

Install this unit in the corner at a 40º to 50º angle from

the adjacent walls.

40° to 50°

An object, such as furniture

Correct

Connecting external components to this unit

Connect this unit to external components such as your TV, DVD player, VCR, digital satellite tuner, cable TV tuner, game console and a subwoofer.

■ Connecting a TV and a DVD player

Connect a TV and a DVD player to this unit. If you connect a subwoofer to this unit, you can enjoy reinforced low bass sounds.

Note

For further information on connecting other components, see pages 15 to 23 in the supplied Owner's Manual.

DVD player

Coaxial

Rear

digital

output

Side

Digital audio pin cable

Video pin cable

(supplied)

Rear panel of this unit

DVD

AUX

TV/STB

COAXIAL

OPTICAL

TV/STB

VCR

REMOTE IN

DIGITAL IN

AUDIO IN

SUBWOOFER

RS-232C

Optimizer microphone (supplied)

■ Installing the optimizer microphone

Use a tripod or the supplied cardboard microphone stand to place the optimizer microphone at the same height as your ears would be when you are seated in your listening position.

Note

Be sure to place the optimizer microphone on an imaginary center line drawn from this unit.

Check the following points before starting the AUTO SETUP procedure.

• Is the optimizer microphone firmly connected to this unit?

• Is the optimizer microphone placed in a proper location?

• Are there any large obstacles in between the optimizer microphone and the walls in your listening room?

Optimizer microphone position

More than 2 m

Imaginary

center line

Note

If your TV has component video input jacks, connect