Yamaha DPX-1100 Owner's Manual page 18

Turning the projector power on
N Placing the DPX-1100 in standby mode
button STANDBY/ON button
AUTO
V. POS ZOOM FOCUS
IRIS SETTING PATT
ESCAPE
ESCAPE MENU
PATTERN
ASPECT
LAMP
ASPECT INPUT
Remote Control Main unit
AC inlet
OUT IN
HDMI RS-232C
REMOTE
INPUT B INPUT A
RGB/YP P /YC C D4 VIDEO G/Y B/P /C R/P /C HD/SYNC VD S-VIDEO
B R B R B B R R
14
1. Press the STANDBY/ON button.
A confirmation message appears on the
screen.
STANDBY/ON
MENU
SETTING
INPUT
COVER TEMP FAN
2. If you wish to place the DPX-1100
in standby mode, press the
STANDBY/ON button again.
The lamp changes to a half lit state, and the
fan activates for 2 minutes to cool the lamp.
During this time, the STANDBY/ON
indicator blinks orange, and pressing
STANDBY/ON does not turn main unit
power on again. When the unit finishes
cooling, the fan stops, and the STANDBY/
ON indicator turns orange.
Memo
• The lamp may blink when half lit. This is not a defect.
Warning
• Do not remove the power cable while the STANDBY/ON indicator is blinking green
or when the fan is activated. This could damage the lamp or reduce lamp life.
3. If you do not plan to use the main
unit for a long period of time,
attach the lens cap and remove
the plug from the AC outlet.
TRIGGER OUT
VIDEO
Warning
• Condensation may appear on the unit if the temperature of the surrounding
environment changes quickly. Condensation may also cause the projected image to
be cloudy. Place the unit in standby mode until the condensation disappears.
Switching the unit on when condensation is present may damage the unit.
Press again to enter standby.