Yamaha YDP-151 Owner's Manual page 35

2-5 Securely tighten the screws on the top of B
that were attached in Step 2-2.
E
2-1
Place the bottom
ends of the rear
panel on each foot.
2-3
2-4
3.
Securely tighten the screws on C that
were attached in Step 1-3.
B
3
4.
Mount A.
Be sure to place your hands at least
10 cm from either end of the main
unit when positioning it.
A
At least
10 cm
E
B
CAUTION
• Fingers can become pinched between the main
unit and the rear or side panels, be extra careful
so as not to drop the main unit.
• Do not hold the keyboard in any position other
than the position shown in the illustration.
2-2, 2-5
B
D
2-3
C
D
5.
Secure A.
5-1 Adjust the position of A so that the left and
right ends of A will project beyond D and E
equally when seen from the front.
5-2 Secure A by tightening the short screws 2 (6
× 16mm) from the front.
Projection
of A
6.
Connect the pedal cord.
6-1 Insert the pedal cord plug to the pedal con-
nector from the rear.
6-2 Attach the cord holders to the rear panel as
shown, then clip the cord into the holders.
6-3 Use a vinyl tie to take up any slack in the
pedal cord.
6-3
YDP-151/YDP-323
5-1
A
5-2
6-1
6-2
Keyboard Stand Assembly 35