Create Continuous - Yamaha QY70 Owner's Manual

This job makes it possible to create continuous data of the specified
type in order to produce smooth pitch bends, aftertouch, etc.
Data type
parameter
The "TR" parameter selects the track to be affected by the Create
Continuous job: D1, D2, PC, BA, C1, C2, C3, C4.
The "M" parameters above the graphic bar are used to specify the
first measure:beat and last measure:beat of the range to be modified.
The data type parameter determines the type of data to be created.
PB
CC
CAT
EXC
The "Data" parameters set the range of data values to be created:
the left number sets the starting value and the right number sets the
ending value. The range of values available will depend on the type of
event selected.
The "Clock" parameter sets the spacing between the created
events in clocks: "000" ... "999".
T h e P a t t e r n

12 : Create Continuous

Pitch bend events.
Control change events. When this event type is selected a control
change number parameter appears to the right of the type
parameter. The control change parameter determines the MIDI
control change number to be created: "000" ... "127".
Channel aftertouch events.
Master volume.
J o b s
First measure. Last measure.
First beat. Last beat.


 
11
179