Technical Procedure
Applies to: S-TRc, 8-TR ( 9-9191, 9-9192, 9-9194, 8-TRx (9-9201, 9-9202, 9-9204, 9-9251, 9-9252, 9-9254)
Required Tools:
•
PHILLIPS SCREWDRIVER
•
CABLE TIE FLUSH CUTTERS
Required Parts:
•
715-4286 "KIT, UPGRADE, RESISTOR, 100OHM, 8-TR/TRx"
If 715-4286 "KIT, UPGRADE, RESISTOR, 100OHM,
8-TR/TRx" arrives and the resistor is not assembled
to the dust shield, insert one clip into each end
of the resistor then use the supplied hardware to
mount the resistor to the dust shield
1.
Remove the motor cover shroud, then using a
phillips screwdriver, remove the four (4) #10-
24 x 1/2" pan head screws securing the dust
shield to the frame, then remove the dust
shield.
2.
Install the dust shield-resistor assembly back
into the treadmill, securing with the four (4)
screws removed in Step 1.
S-TRc/8-TR/8-TRx Resistor Kit Install Instructions
Page 1
620-8637 Rev. F