Yamaha Electone EL-100 Owner's Manual page 128

9.
Connect the AC Power Cord plug to the AC Inlet
of the Main Unit.
10.
Place the Music Stand.
11.
Turn on the Electone's power switch and confirm
that the Electone can be played, or that the
assembly is successful.
11
128
BENCH ASSEMBLY
Reverse the bench board and place one of the legs to the
corner of the bench board, then tighten the nut using the
included wrench. Be sure to put the washer between the
leg and the bench board.
■ After completing the assembly, please check the following
items.
• Are there any parts left over?
fi Review all assembly procedures.
• Is the Electone clear of doors and other movable
fixtures?
fi Move the Electone to an appropriate location.
• Does the Electone make a rattling noise when you
shake it?
fi Tighten all screws.
• Can the Electone be turned on?
fi Confirm that the AC power cord plug is securely
connected to the Electone's AC Inlet and the other
side of the cord is connected to an appropriate power
outlet.
• Does the Electone produce sounds?
fi Confirm that the Speaker cord plug and the Pedalboard
cord plug are securely connected to each socket on
the Main unit.
If the Electone creaks or is otherwise unsteady when you
play on the keyboard, refer to the assembly instructions and
tighten all screws again.
leg
washer
nut
bench
board