Click Out Select - Yamaha DTXPLORER Drum Trigger Module DTXPLORER Owner's Manual

Play Along With The Metronome
8. Save an Original Click Set
After creating your own original click set, save it in the
DTXPLORER's memory using the Store Operation de-
scribed below.
* Any changes made to the data will be lost if another click set
is selected before carrying out the store operation.
8-1. Press the [SAVE/ENT] button. The following display will
appear.
8-2. Rotate the jog dial to select the destination memory num-
ber (1 to 30) that you want to store the click set in.
8-3. Press the [SAVE/ENT] button again and the following
display asking your confirmation to proceed with the store
operation.
8-4. Press the [SAVE/ENT] button to carry out the store op-
eration.
* To cancel the store operation, press any button except
for the [SAVE/ENT] and [SHIFT] buttons (when "Are you
sure?" appears in the display, the jog dial will also can-
cel the operation).
The following display appears after the store operation is
complete.
You can use the "Factory Set" operation to reset the
contents of click sets 1 through 30 to their original
factory condition.
However, please proceed with caution because carry-
ing out this operation will rewrite the DTXPLORER's
entire contents (all click sets, user trigger setup (No.
5), user drum kits 33 to 42) with the data that was set
in the unit's memory when it was shipped from the
factory. (P. 23)
16
The DTXPLORER lets you select from which output jack
the metronome's signal is delivered. Click output and per-
formance output can be routed to separate outputs.
Procedure
1. Press the [SHIFT] + [SAVE/ENT] buttons and the
2. Next, press the [>] button twice so that the follow-
Store
Destination
3. Rotate the jog dial to select the output from the out-

Click Out Select

following display will appear. (Page 1 in the Utility
Mode.)
ing display appears.
puts listed below.
: This is the standard output setting. The
click signal is delivered from both the OUT-
PUT L and R jacks.
: The click signal is delivered from the OUT-
PUT L jack only. All drum performance and
song playback is delivered in monaural via
the OUTPUT R jack.
: The click signal is delivered from the OUT-
PUT R jack only. All drum performance and
song playback is delivered in monaural via
the OUTPUT L jack.
* The PHONES jack delivers the same signal as the
OUTPUT jacks. The settings in this section would then
be applied to the PHONES jack's stereo L and R.