Switching On The Power; Data Backup & Initialization - Yamaha DJX-IIB Owner's Manual

Switching On the Power

Once you've set up your DJX-IIB, try turning the power on.
Make sure your sound system's main level/volume control(s) and the DJX-IIB volume con-
trol are turned all the way down prior to turning the power on.
• Even when the switch is in the "STANDBY" position, electricity is still flowing to the instru-
ment at the minimum level. When you are not using the DJX-IIB for a long time, make sure
you unplug the AC power adaptor from the wall AC outlet, and/or remove the batteries from
the instrument.
Data Backup & Initialization
Except for the User Pattern data, all DJX-IIB panel settings are reset to their initial set-
tings whenever the power is turned on. The Use Pattern data is backed up (i.e.
retained in memory) as long as an AC adaptor is connected or a set of batteries is
installed.
All data can be initialized and restored to the factory preset condition by turning on
the power while holding the LOOP button. "Clr!" will appear briefly on the display.
• All settings listeda bove, will be erased and/or changed when the data initialization procedure is
carried out.
• Carrying out the data initialization procedure will usually restore normal operation if the DJX-IIB
freezes or begins to act erratically for any reason.
Set the MASTER VOLUME
knob to "min."
Turn the power ON by pressing the
STANDBY/ON switch.
Press the STANDBY/ON switch
again to turn the power OFF.
C|r'.
0J'.
13