To Program Buttons
Store dialings sequences or features on programmable buttons (see diagram, panels
2–3). Then simply press the button to dial or access the feature automatically.
1.
Press [
] [
Feature
2.
Press a programmable button.
3.
Press the buttons you normally press to dial an extension, outside number, or
feature (see examples below). To remove a feature, press [
NOTE: To store the [
To program more buttons, or to change the programming, repeat Steps 2 and 3.
4.
Press [
] [
Feature
Examples:
An extension jack number
To ring extension jack 11 with one touch, program [
page exetension jack 11, program [
button to see at a glance when the extension is busy (red steady light) or calling
you (green flashing light.)
A telephone number*
To dial 9-555-5678 with one touch, program [
(The "9" in the example is a Centrex dial-out code for an outside call. Your code may be
different, or you may not need one.)
A Centrex feature code
To store a Centrex feature code *999, program [ ] [
To use that feature while on a call, program [
Any equipment feature on panel 5 or 6
In general, you can program [
For example, to use Do Not Disturb with one touch, program [
a button with lights. To answer a call ringing at any extension in Pickup Group 2,
program [
Intercom
To Program Personal Speed Dial Numbers
1.
Press [
] [
Feature
2.
Press [
], then press the two-digit Dial Code (80-99) you want assigned
Feature
to the phone number.
3.
Enter an outside phone number or Centrex extension number.
To add more numbers, repeat Steps 2 and 3.
4.
Press [
] [
Feature
To change a number, follow Steps 1-4.
To Program Special Characters in a Dial Sequence
To insert a . . .
Pause (1.5 seconds)
†
Stop
Touch-Tone Enable
Recall
* An outside number can have a maximum of 20 digits, including special characters.
†
Not available on MLS-6 phones.
Programming
] [
] to enter program mode.
0
0
] button, press the left [
Intercom
] [
] to exit program mode.
0
0
Feature
] [
] [
] [
] on a button.
6
6
2
] [
] to enter program mode.
0
0
] [
] to exit program mode.
0
0
Press . . .
[
]
Hold
[
]
Mic
[
Transfer
[
]
Spkr
Intercom
Intercom
] [ ] [
] [
]. You can also use this
Intercom
1
1
] [
] [
9
5
9
] (Recall) [ ] [
Spkr
] and the two-digit feature code on a button.
Appears on Display as . . .
]
4
†
].
Mic
] button.
] [
] [
]; to voice
1
1
] [
] [
] [
] [
] [
5
5
5
6
7
8
] [
] [
].
9
9
] [
] [
].
9
9
9
] [
] [
Feature
0
P
S
T
R
].
] on
1