Table of Contents
Advertisement
Installation Guide
Figure 34: OpenFlex F3100 Slot Identification
Step 14 : Once the enclosure has been powered on and populated with devices, the E3000 will use DHCP
to establish an IP. The default hostname set during this process will be
of-mac-address}
navigate to the default hostname of the BMC Module.
Example Mac Address:
Resultant Hostname Based on Mac Address:
Step 15 : Verify the health of the system using the OCGUI.
a. Once all of the devices have been installed refresh the BMC Module.
b. Click on the devices list to show a procedurally generated list of all devices, including the
enclosure, that exist on the fabric. The BMC Module id should be listed.
c. Click the blue "link" icon next to the E3000 listed in the devices. This will link to the device
status page.
d. Click on the power supplies icon and verify that there are two PSUs listed, and that the
status indicator reads OK.
e. Click on the Fans icon and view all of the fans listed in the summary. All of the icons in the
health column should read OK.
1.5 Accessing Storage
Step 1 : Enter a valid username and password, and click the Login button:
. Use the mac address that was recorded earlier in Step
00:0C:CA:09:00:33
e3000-090033
1. Installation
1.5 Accessing Storage
e3000-{last-3-bytes-
8 (page 14)
to
23
Advertisement
Table of Contents
