Tuner Mode; Using The Tuner - Yamaha Magicstomp Bass Effects Processor Owner's Manual

Yamaha bass effects processor owner's manual
Table of Contents

Advertisement

Tuner Mode

This mode is used for tuning your bass. In the Tuner Mode, the MAGICSTOMP functions
as a chromatic tuner.
* The signal from the MAGICSTOMP's OUTPUT jack and PHONES jack is muted when in the Tuner Mode (no
sound will be produced).
I Using the tuner
1
Press and hold the ON/OFF switch until the tuner display (shown below) ap-
pears on the display.
With your bass connected to the INPUT jack, use the display to tune your bass.
* The Tuner Mode is not available during the store operation.
2
If you want to use a standard pitch other than 440Hz, use the – or + switches.
The standard pitch can be set anywhere between 438Hz and 445Hz in the MAGICSTOMP.
3
Play the string you want to tune (play a single tone).
1. First, tune the bass until the name of the note you want to tune to appears on the display.
2. When the string's pitch is low,
When the string's pitch is high,
The string's pitch is in tune when "
lamp is lit.
4
Press the ON/OFF switch to return to the original display.
24
mark will be displayed and the – switch's lamp will be lit.
mark will be displayed and the + switch's lamp will be lit.
" appears in the display and the ON/OFF switch's
In Tune!
Note Name
Standard Pitch

Advertisement

Table of Contents
loading

This manual is also suitable for:

Magicstomp

Table of Contents