Yamaha DSP5D Owner's Manual page 155

❏ Cascade master (bi-directional cascade
connections between PM5D units)
1 In the DISPLAY ACCESS section, repeatedly
press the [SYS/W.CLOCK] key until the MIXER
SETUP screen appears.
MIXER SETUP
CASCADE CONNECTION area
2 In the CASCADE CONNECTION area located at
the bottom of the screen, click the TYPE
SELECT button to access the CASCADE TYPE
SELECT window.
3 Select "PM5D - PM5D" as the connection type,
and click the OK button to close the window.
4 In the CASCADE MODE area at the lower part
of the screen, select "MASTER". In addition,
turn on the BI-DIRECTION button located
immediately below it.
CASCADE MODE area
When multiple PM5D units are cascaded, the settings
of the CASCADE MODE area specify whether the unit
will operate as a cascade master (when "MASTER" is
selected) or as a cascade slave (when "SLAVE" is
selected).
If you turn the BI-DIRECTION button on, the mixed
audio signals of both cascade-connected PM5D units
will be output from both units.
BI-DIRECTION button
PM5D/PM5D-RH V2 / DSP5D Owner's Manual
5 Select "PM5D" in the CASCADE FROM field
and in the CASCADE TO field.
CASCADE FROM
field
In the CASCADE FROM field, select one of the follow-
ing as the type of the external device that is sending
signals to the PM5D via the cascade connection.
Source
Display
device
CASCADE IN,
Cascade dis- SLOT 4, SLOT 3/4,
—
abled SLOT1-4 [CH1-8],
SLOT 1-4 [CH9-16]
PM5D another PM5D CASCADE IN
Yamaha
DM2000
DM2000 or CASCADE IN
/02R96
02R96
A mixer other
SLOT 3/4,
MIXER than the above
SLOT 1-4 [CH1-8],
[30BUS] (maximum 30
SLOT 1-4 [CH9-16]
bus)
A mixer other
MIXER than the above
SLOT 4
[16BUS] (maximum 16
bus)
*1. Linked parameters are specified in the CASCADE
screen.
In the CASCADE TO field, select either "PM5D" or "--
--" (transmission disabled) as the external device to
which the signal will be sent from the PM5D via the
cascade connection.
6 Make sure that "CASCADE IN" is selected for
the CASCADE IN PORT SELECT field, and "CAS-
CADE OUT" is selected for the CASCADE OUT
PORT SOURCE SELECT field.
CASCADE IN PORT
SELECT field
The CASCADE IN PORT SELECT and CASCADE
OUT PORT SOURCE SELECT fields select the ports
Operating section
CASCADE TO field
Selectable cas- Parameter
cade input port linkage
Not
possible
*1
Possible
Not
possible
CASCADE OUT PORT
SOURCE SELECT field
155
19