Starting And Warming Up A Cold Engine - Yamaha FJR1300 Owner's Manual

O PERATION AND IMPORTANT RIDING POINTS
5 -
WARNING
_
Become thoroughly
with all operating controls and
their functions before riding.
Consult a Yamaha dealer re-
garding any control or function
that you do not thoroughly un-
derstand.
Never start the engine or oper-
ate it in a closed area for any
length of time. Exhaust fumes
5
are poisonous, and inhaling
them can cause loss of con-
sciousness and death within a
short time. Always make sure
that there is adequate ventila-
tion.
Before starting out, make sure
that the sidestand is up. If the
sidestand is not raised com-
pletely, it could contact the
ground and distract the opera-
tor, resulting in a possible loss
of control.
_
EAU00373
Starting and warming up a
cold engine
familiar
In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:
The transmission is in the neutral
position.
The transmission is in gear with
the clutch lever pulled and the
sidestand up.
WARNING
_
Before starting
check the function of the igni-
tion circuit cut-off system ac-
cording
described on page 3-18.
Never ride with the sidestand
down.
_
1. Turn the key to "ON" and make
sure that the engine stop switch is
set to " ".
EAU04096
_
The oil level warning light and en-
gine trouble warning light should
come on for a few seconds, then go
off. If a warning light does not go off,
see pages 3-2 and 3-3 for the corre-
sponding
check.
_
EW000054
NOTE:
_
the engine,
When the transmission is in the neutral
position, the neutral indicator light
should be on, otherwise have a
to the procedure
Yamaha dealer check the electrical cir-
cuit.
_
5-1
CAUTION:
warning light
2. Shift the transmission into the neu-
tral position.
3. Start the engine by pushing the
start switch.
EAU00372
ECA00083
circuit