IBM Aspera HST Admin Manual page 51

Field
Outgoing Bandwidth
Policy Lock
Outgoing Priority
Allowed
Outgoing Priority Default The initial priority setting. Use the value
Outgoing Priority Lock
Outgoing Rate Control
Module
Description
but less aggressive when sharing
bandwidth with other network traffic.
When congestion occurs, the transfer
rate is reduced to the minimum rate
until other traffic decreases.
• fixed - Attempt to transfer at the
specified target rate, regardless of
network or storage capacity. This can
decrease transfer performance and
cause problems on the target storage.
Aspera discourages using the fixed
policy except in specific contexts,
such as bandwidth testing. The fixed
policy requires a maximum (target)
rate.
Lock the bandwidth policy of outgoing
transfer sessions to the default value (set
to true). Set to false to allow users to
adjust the bandwidth policy.
The highest priority your client can
request. Use the value 0 to unset this
option; 1 to allow high priority, 2 to
enforce normal priority.
0 to unset this option, 1 to allow high
priority; 2 to enforce normal priority.
To prevent your clients from changing the
priority, set the value to true.
Set how the transmission rate should
be managed relative to instantaneous
network bandwidth availability. Aspera
recommends that this option be changed
only by advanced users.
When the client does not specify a
configuration, the server configuration is
used. When the client specifies a value
other than delay and the client is the
receiver, then the client configuration
overrides the server configuration.
Values:
delay: The baseline rate control
•
module used by Aspera transfers.
• delay-odp: A queue-scaling controller
for overdrive protection.
• delay-adv: An advanced rate
controller.
• delay-laq: A loss-adjusted queueing
(LAQ) rate controller.
| Configure the Server from the Command Line | 51
Values Default
true or false false
0, 1, or 2 1
0, 1, or 2 2
true or false false
delay, delay- delay
odp, delay-
adv, or delay-
laq